ข้อกำหนดของเครื่องขึ้นรูปม้วน

Different customers have different ข้อกำหนดของเครื่องขึ้นรูปม้วน. Here will talking about the basic requirements

ข้อกำหนดของเครื่องขึ้นรูปม้วน

Satisfying Customers

Roll formed products are sold to customers in a very competitive market. Customers are always looking for manufacturers who will repeatedly meet with their basic necessities. they’re expecting to receive:

The proper quality
The proper amount of merchandise
At the proper time
For the proper value

Companies powerless to produce the proper quality or the proper amount, at the proper time for the proper value will lose their customers. However, not systematically meeting customers’ expectations or having manufacturing issues isn’t continually the plant’s fault. The plant cannot manufacture good quality products at the proper time for the proper value if they’re not given the fundamental mechanisms to satisfy
their obligations.

Roll Forming Machine Requirements of Factory

To successfully meet the demands and beat the competitors, producing plants must have:

Good design
Adequate run quantities
The proper material
The proper equipment
Good tooling and
Knowledgeable, intended workforce

Good design

Most plants have experience with products that can’t be expeditiously roll formed, or generally not roll formed at all. the product will be too complicated for the obtainable equipment, or the size or tolerances are on the far side the capabilities of the instrumentation or tooling.

Sufficient run quantities

If the run quantities square measure below a cost-effective minimum level, then high setup cost will reduce potency unless the plant has a special purpose line set up for that specific product. Very high run quantities could reduce product prices but can increase inventory, product-handling value, and storage space requirement.

Acceptable quality material.

Running across “bad material” isn’t a rare occurrence. maybe the supplied material was either unsuitable for the product, or it may have been incorrectly specified. However, once troubleshooting of the equipment and tooling doesn’t yield fast results, the material is far too ofttimes, and infrequently incorrectly, goddamn for the dangerous merchandise.

Proper equipment

Appropriate for forming the product. there’s no plant while not complaints about the roll forming lines. Frequently, the complaints are justified; generally, it’s the results of procuring a line of insufficient capability or dangerous quality, or of neglected maintenance or abusive usage by the operator. The life of a good-quality, reasonably well-maintained roll former may be over fifty years. Most bad equipment issues square measure corrected within the 1st year, and also the mill can operate with reasonable responsibility. However, incorrectly specified, slow, weak, or low-quality lines can’t be made competitive against quicker and better lines.

Good tooling

Roll forming lines square measure equipped with many sets of tooling throughout their lifetime. Good quality, operator-friendly, properly set up tooling is crucial to provide good-quality products at reasonable value.

Knowledgeable, motivated work force.

It’s been explicit repeatedly that the best quality of a company is its people. a company will have a wonderful product, good material, the best equipment and tooling, but is still unable to produce competitively without knowledgeable individuals. Continuous education of the operators and other employees, combined with motivation, is crucial to sensible productivity and profit.

บริษัท เบลลี อินดัสทรี have a full range of roll forming machines for different requirements. ติดต่อเรา สำหรับข้อมูลเพิ่มเติม